FAQ Collections
The U2AUDIO7-1 cannot output 5.1 from Logitech Z-640 system
Posted by VTOP-eMall on

U2AUDIO7-1 on Logitech Z-640 system. It works on 6.1 but the sound output seems not the right channel. But on another PC, Z-640 seems the right output. Reply The U2AUDIO7-1's Standard Definition Audio Output. (Please neglect the U2AUDIO7-1's Audio Jack's Color.) 1. FRONT - Left/Right2. SURROUND - Left Surround/Right Surround3. CENTER/BASS - CENTER(Left Earphone) / BASS (Right Earphone)4. BACK - Left/Right (Only at 7.1 mode) STEP 1 - Make Settings on U2AUDIO7-1's Setting Panel. The Logitech Z-640 is a 6-channel Audio Speaker System, so let's set the U2AUDIO7-1's Audio output to 6-channel. STEP 2 -Test the Audio Output Channel...
- 0 comment
- Tags: Logitech Z-640, U2AUDIO7-1
Does V.TOP USB232A-B Works With Raspberry Pi?
Posted by VTOP-eMall on
Well, we tested V.TOP USB232A-B on Raspberry Pi 3B+ (Debian GNU). The following videos are for your reference. Raspberry Pi 3B+ reads it without installing any drivers. Step 1 - Raspberry PI 3B+ Configuration Step 2 - How to enter into Raspberry PI 3B+ Step 3 - Check the Hardware Today's Promotion Code - VBKCD946PR4X
V.TOP CU200 @ Raspberry pi
Posted by ChenChris on
The two connections are on the same IP segment. They are configured in Linux with no IP address. Traffic will be bridged across the 2 ports as shown in the diagram. The USB to Dual Ethernet cable is attached to a USB 3.0 port on a Raspberry Pi running Debian 10 Buster.When I power on the Raspberry Pi we see only one ethernet interface on the adapter. When I unplug the adapter, and connect to another USB3.0 port on the Raspberry Pi, both ethernet interfaces appear under Linux.Once both ethernet interfaces are found, the cable operate in bridge more with no...
AVC08-V2 / AVC05-V2 -Windows OS Has no audio
Posted by VTOP-eMall on
OS: windows10VHS: Panasonic PV-D4762Cannot record audio, although when first installed it did record audio for about a dozen tapes. Nothing changed from one tape to another. Solution Since the Video-Grabber Recorded some tapes successfully. So let's check w/ the following 3-steps. Recording Settings ---> Audio Device: Settings --> "Enable" Pin Line Input Mix.
AVC05 - (Windows 10) Where is my recorded file
Posted by VTOP-eMall on
Model No.: AVC05-V2 VHS to DVD programme can not record video files as mpg4 format. Can you help? Reply honestech VHS to DVD 4.0 SE is an official Commercial Video Catpure Application Software for Analog Video Capture Device. The max resolution is truly limited compared to present 1080p files. It automatically creats MPEG format @ Level 2 (MPEG2). The details are as following: However, it is a luck that AVC05-V2 also supports on Potplayer or OBS. As for how to use VHS to DVD to record video. Let's take a look at the following instructions. Step 1 - Connect Hardware...